 |
HFLINK Home
|
|
Ham Radio Bandplans
|
|
|
|
JT65-HF Frequencies
|
|
VFO FREQ
|
|
28076.0 kHz USB
|
|
24917.0 kHz USB
alternate 24920.0 kHz USB
|
|
21076.0 kHz USB
|
|
18102.0 kHz USB
alternate 18098.0 kHz USB
|
|
14076.0 kHz USB
alternate 14075.0 kHz USB
|
|
10139.0 kHz USB
alternate 10138.0 kHz USB
alternate 10137.0 kHz USB
|
|
7039.0 kHz USB
alternate 7036.0 kHz USB
(USA) 7076.0 kHz USB
|
|
3576.0 kHz USB
|
|
JT65A MF Frequencies
VFO Freq
1838.0 kHz USB
alternate 1805.0 kHz USB
501.0 kHz USB
505.0 kHz USB
|
|
JT65A LF Frequencies
VFO Freq
136.13 kHz USB
Signal Freq:
137.4-137.6 kHz
|
|
Terrestrial JT65A
VHF Frequencies
|
|
VFO FREQ |
- |
144.076 MHz USB
|
- |
144.116 MHz USB
|
-
|
144.160 MHz USB
144.120 MHz USB
|
- |
50.076 MHz USB
|
-
|
50.160 MHz USB
|
-
|
50.260 MHz USB
|
|
50.276 MHz USB |
|
50.290 MHz USB |
|
|
|
other Information about JT65A:
|
|
Was it a "real QSO"?
is Deep Search really decoding callsigns?
|
|
QSO talk site
|
|
Are the digital bits being decoded?
|
|
Analysis of Deep Search
|
|
JT65A Software Download:
|
|
Software
|
|
Software
|
|
|
|
JT65A operators use USB VFO FREQUENCY for spots.
Note:
Multiple frequencies are listed on some bands, due to: amateur radio
rules in different countries and the need for alternate frequencies by
various operators and local interference trends.
|
|
|

|
JT65A frequency
14076.0 kHz USB VFO

JT65A signal is about
+1.3 kHz to +1.5 kHz higher than VFO frequency.
JT65A Passband = 355Hz
JT65A frequency
10139.0 kHz USB VFO
|

|
JT65A Signal Passband = 355Hz
JT65A is suitable for use in the 500Hz Bandwidth segments of ham radio bandplans.
The most popular JT65A frequency is in the 20 Meter band:
The JT65 frequency 20metres is 14076.0 kHz USB VFO.
The JT65a sync frequency is 14077.27 kHz.
The JT65 signal frequency is about 14077.3 to 14077.7 kHz.
|
The JT65A frequency 30metres is 10139.0 kHz USB VFO.
The JT65a sync frequency is 10140.27 kHz.
*Do not use a sync frequency less than 10140.2 kHz.
The JT65 signal frequency is about 10140.3 to 10140.7 kHz. This transmit signal is within the 10140-10150kHz automatic digital sub-band.
*Special Note: Do not transmit within 10139.9-10140.1 kHz QRSS CW weak signal window!
|
|
International JT65A frequency 40metres is 7039.0 kHz USB VFO.
The International JT65A sync frequency is 7040.27 kHz
The JT65A signal frequency is about 7040.3 to 7040.7 kHz.
The JT65A frequency 40meters (USA) is 7076.0 kHz USB VFO.
The JT65A sync frequency (USA) is 7077.27 kHz
The JT65A signal frequency is about 7077.3 to 7077.7 kHz.
|
The JT65A frequency 17metres is 18102.0 kHz USB VFO.
The JT65A sync frequency is 18103.27 kHz
The JT65A signal frequency is about 18103.3 to 18103.7 kHz.
The JT65A alternate frequency 17meters is 18098.0 kHz USB VFO.
|
The JT65A frequency 12metres is 24917.0 kHz USB VFO.
The JT65A sync frequency is 24918.27 kHz
Note: before date 9/2011, the
old JT65A frequency was 24920 kHz (changed to avoid QRM)
|
IMPORTANT INFORMATION
ABOUT ALL JT65A FREQUENCIES
-
JT65A operators use USB VFO FREQUENCY for spots.
-
JT65A signal is about 1.3+kHz higher than the VFO frequency
- The JT65A Passband is about 355Hz. Bandwidth is about 200Hz.
- JT65A may be used in the 500Hz bandwidth segments of bandplans.
- Normal operation of JT65A is a sync audio frequency of 1270.5Hz.
- Sync tone is the reference mouse-click frequency for JT65.
-
JT65A signal bandwidth extends about 200Hz above 1270.5Hz sync.
- The lowest tone of the JT65 signal is normally 1270Hz.
-
The system allows approximately +/-600Hz auto-tuning on receive.
source: specifications
JT65A/JT65/JT65-HF mode is normally used on HF, MF, LF and 6 meter bands.
Special Notes on Good Operating Procedure:
1. Operators should be careful of frequency selection, accurate clock, and calibration.
Always listen and observe the waterfall spectrum of signals on the
frequency before transmitting, and during activity.
2. JT65A is a weak signal digital QSO mode. Always use very low power on HF
to avoid QRM to other JT65 signals and other modes. 20Watts ERP is
maximum for normal activity and DXing in the 40metre to 10metre bands.
3. Normal activity of JT65A is in the "weak signal" part of the ham
bands, near the PSK, MFSK, and Olivia 500 frequencies. JT65A should not
be used in parts of the ham bands where faster digital modes are in use.
4. The long tone carrier duration of JT65 transmissions has potential to cause severe interference to other
modes.
5. Do not use JT65 in 10144kHz-10150kHz
because JT65A is NOT COMPATIBLE with MFSK, FSK, HELL, OLIVIA,
CONTESTIA, ALE400, or RTTY and can cause severe interference to fast
time-sharing modes such as PACKET, PACTOR, ALE, PSKmail, and APRS.
Multiple JT65 frequencies are listed on
some bands, due to:
A) Amateur radio band rules are different in some countries.
B) The
need for alternate frequencies if QRM is experienced.
C) Local or regional
interference on a main frequency.
D) Coordination with the changing spectrum utilization of the amateur community.
E) The high popularity of a new mode-du-jour may create a temporary need to find a new or alternate calling frequency.
F) There are many competing modes in the weak signal part of the digital bands.
|
|
|
|
|
END OF PAGE
©2000, 2001,
2002,
2003,
2004, 2005, 2006, 2007, 2008 ,2009, 2010, 2011 HFpack Inc. All Rights Reserved.
HFLINK, HF-LINK, HF LINK, and the HFLINK Logo
are trademarks of HFpack Inc. Any external hyperlinks must only be to the main page of the HFLINK.COM
website
http://hflink.com . Capture of the HFLINK website or any part of it
within
the frame of another website is not permitted. HFLINK group forum is a
private group. Public archiving,
forwarding,
or open display on the internet of HFLINK group forum or messages is
forbidden.
All text and images on the HFLINK website are property or copyright
HFpack Inc, or when used by permission, are copyright by their
respective
owners, with all rights reserved.
HFN and High Frequency Network are service marks and trademarks of HFpack, Inc. No part of the HFLINK website or HFLINK Group
Forum
may be used or copied without written permission of HFpack Inc.
|
|
|